The AutoCleaver LDF from Fujikura is a high precision fibre cleaver, designed for cleaving of Large Diameter Fibres up to 1000um. An unique and patentpending cleaving process generates typical cleave angles of less than 0.5°.
The built in microprocessor controls all vital parameters and settings, such as fibre alignment, clamping, fibre tension and the exact position and speed of the diamond blade. This control of sensitive parameters guarantees a high cleaving repeatability and accuracy.
Cleaving performance is enhanced by the use of fibre handling kits that are optimised for a specific fibre dimension. The fibre is held in place by an external fibre holder that is used on the splicer to be used. The cleaver is designed to generate minimum amounts of fibre waste, typically less than 20mm. An automatic waste disposal system removes any hazardous fibre scraps.
The cleaver can be connected to an external PC, that gives access to all programmable parameters and settings.
The AutoCleaver LDF has a small bench top design.
Features:
Low cleave angles, <0.50°
Minimal hackle
Minimal diamond intrusion
Fully automatic
Operator independent
Waste fibre deposition
Long life with durable blade.
Specifications:
Fibre Cladding: 250-1000um
Fibre Coating: 300-1500um
Cleave Angle: Typical <0.5°
Power Source: External Power Supply 90 - 264V
Compressed Air: External compressor or air bottle, 6 Bar of pressure with a 4mm instant push-in fitting
PC Connection: RS-232
Dimensions (L x W x D): 175(W) x 138(D) x 104(H) mm
CE Conformity: Fully complies with all EC equipment guidelines according to the CE Declaration of Conformity
Nyfors AutoCleaver LDF in details:
For more informations about Nyfors AutoCleaver LDF, please consult the following document:
fibre_optics_Nyfors-AutoCleaver_LDF.pdf (259.96 KB)
